As prescribed in 45.106(111) insert the following clause:
GOVERNMENT-FURNISHED PROPERTY (GFP) MECHANICAL GAUGES (LOANED) (INCLUDES FSCS 5995 AND 6150)
(Jul 2008) - DLAD
(a) Purpose and Use of GFP Mechanical Gauges:
(1) Gauges shall be subject to the requirements of:
(i) ISO/ANSI/ASQC Q9001 or Q9002, or equivalents
as applicable; and
(ii) ISO 10012-1 or ANSI/NCSL Z540-1-1994, or
equivalents.
(2) The Contractor shall thoroughly check the gauge drawings against the Government-furnished equipment drawings. Discrepancies shall be reported in writing to the Contracting Officer. Negative reports are required.
(3) Gauges shall be used only for quality conformance inspection in accordance with specification and/or drawing(s).
(4) The Contractor shall make gauges available to Government Quality Assurance Representative in accordance with inspection requirements applicable to this contract.
(b) Return of GFP Mechanical Gauges to the Government:
(1) When the GFP mechanical gauges are no longer required for use by the Contractor or Government Quality Assurance Representative, but no longer than completion of the delivery of end items or termination of this contract, the Contractor shall deliver to the Government all of said GFP gauges, unless directed otherwise by the Contracting Officer.
(2) The Contractor shall notify the cognizant Government quality assurance activity to arrange for inspection by the Government Quality Assurance Representative of the
condition of the gauges before they are packed for return to the Government.
(3) The Contractor shall prepare, package and pack such gauges for shipment in accordance with Level B of MIL-G10944 and deliver for return or disposition F.O.B. carrier's equipment, wharf or freight station, at the Government's option, in the city and state of the plant identified in 52.245-9003. The packages shall be marked for the consignee as follows:
U. S. Army District TMDE Support Center
ATTN: AMXPM-GA-T
11 Hap Arnold Blvd, Bldg 12
Tobyhanna, PA 18466-5104
(End of clause)
